Laboratory practice
Peptide net charge, isoelectric point and solubility by pH
Charge at the working pH is the first thing to work out before dissolving a peptide. This page computes it across a pH range for 18 peptides in our library, with the method and its limits shown.
The short version
A peptide's net charge changes with pH because its acidic and basic groups gain or lose protons. The pH where the charges balance to zero is the isoelectric point (pI). Our guide to dissolving peptides for in-vitro assays uses a simple charge count at about neutral pH to choose a first solvent. This page does the same count properly across a range of pH values, so you can see how far a given peptide sits from its pI at the pH you plan to use.
How the numbers were computed
Each peptide's charge is the sum of fractional charges from the Henderson-Hasselbalch relation: for a basic group, 1 ÷ (1 + 10pH−pK), and for an acidic group, −1 ÷ (1 + 10pK−pH). The pK values are those Thurlkill et al. (2006) measured by potentiometric titration in alanine pentapeptides with blocked ends, in 0.1 M KCl at 25 °C: α-carboxyl 3.67, Asp 3.67, Glu 4.25, His 6.54, α-amino 8.00, Cys 8.55, Tyr 9.84 and Lys 10.40. Arg is not among them; it is counted at an assumed pK of 12.5 and is effectively +1 throughout the range tabulated. Cysteines that sit in a disulfide are not titrated.
Grimsley et al. (2009) tabulated 541 pK values measured in 78 folded proteins and found averages such as Asp 3.5, Glu 4.2, His 6.6, Lys 10.5, N-terminus 7.7 and C-terminus 3.3, with wide spreads (for example ±1.2 for Asp and ±2.7 for Cys). Short peptides without folded structure are closer to the pentapeptide model values, but the real pK of a group depends on its neighbours, ionic strength and temperature, so every value below is an estimate with an uncertainty of a few tenths of a charge unit near the pK values.
Computed charge and isoelectric point
| Peptide | Residues | Termini and notes | pH 2 | pH 5 | pH 7.4 | pH 9 | Isoelectric point | Hydrophobic share (A, I, L, M, F, V, W) | First solvent under our dissolving guide |
|---|---|---|---|---|---|---|---|---|---|
| BPC-157 | 15 | Free N-terminus and C-terminal acid | +1.9 | −1.7 | −2.2 | −2.9 | 3.8 | 27% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| KPV | 3 | Free N-terminus and C-terminal acid | +2.0 | +1.0 | +0.8 | +0.1 | 9.2 | 33% | Sterile water; test a small portion first |
| Selank | 7 | Free N-terminus and C-terminal acid | +3.0 | +2.0 | +1.8 | +1.1 | 11.5 | 0% | Sterile water; dilute acetic acid if needed |
| Semax | 7 | Free N-terminus and C-terminal acid | +2.0 | +0.2 | −1.1 | −1.9 | 5.4 | 29% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| DSIP | 9 | Free N-terminus and C-terminal acid | +1.0 | −1.8 | −2.2 | −2.9 | 3.5 | 33% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| Epithalon | 4 | Free N-terminus and C-terminal acid | +1.0 | −1.8 | −2.2 | −2.9 | 3.5 | 25% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| PE 22-28 | 7 | Free N-terminus and C-terminal acid | +2.0 | +1.0 | +0.8 | +0.1 | 10.3 | 43% | Sterile water; test a small portion first |
| Pinealon | 3 | Free N-terminus and C-terminal acid | +2.0 | −0.8 | −1.2 | −1.9 | 4.2 | 0% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| Vesugen | 3 | Free N-terminus and C-terminal acid | +2.0 | −0.8 | −1.2 | −1.9 | 4.2 | 0% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| Kisspeptin-10 | 10 | Free N-terminus, C-terminal amide | +2.0 | +2.0 | +1.8 | +1.0 | 11.2 | 40% | Sterile water; dilute acetic acid if needed |
| VIP | 28 | Free N-terminus, C-terminal amide | +7.0 | +5.1 | +3.9 | +2.7 | 10.4 | 36% | Sterile water; dilute acetic acid if needed |
| Oxytocin | 9 | Free N-terminus, C-terminal amide, Cys1-Cys6 disulfide (not titrated) | +1.0 | +1.0 | +0.8 | 0.0 | 8.9 | 22% | Sterile water; test a small portion first |
| ARA-290 | 11 | N-terminal pyroglutamate (no N-terminal charge), C-terminal acid | +1.0 | −1.7 | −2.0 | −2.0 | 3.7 | 27% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| AOD-9604 | 16 | Free termini, Cys7-Cys14 disulfide (not titrated) | +3.0 | +1.2 | +0.8 | 0.0 | 8.9 | 31% | Sterile water; test a small portion first |
| MOTS-c | 16 | Free N-terminus and C-terminal acid | +5.0 | +3.2 | +2.8 | +1.8 | 10.3 | 38% | Sterile water; dilute acetic acid if needed |
| Humanin | 24 | Free termini; the single Cys counted as a free thiol | +5.0 | +2.2 | +1.7 | +0.3 | 9.5 | 46% | Sterile water; dilute acetic acid if needed |
| Thymosin alpha-1 | 28 | N-terminal acetyl (no N-terminal charge), C-terminal acid | +3.9 | −4.9 | −6.0 | −6.2 | 3.8 | 29% | Sterile water or buffer; dilute ammonium bicarbonate if needed |
| LL-37 | 37 | Free N-terminus and C-terminal acid | +11.9 | +6.6 | +5.8 | +4.9 | 11.0 | 35% | Sterile water; dilute acetic acid if needed |
Read the table as follows. At pH 7.4 the net charge is +1 or more for Selank, Kisspeptin-10, VIP, MOTS-c, Humanin, LL-37. It is −1 or less for BPC-157, Semax, DSIP, Epithalon, Pinealon, Vesugen, ARA-290, Thymosin alpha-1. It lies between −1 and +1 for KPV, PE 22-28, Oxytocin, AOD-9604, the group closest to its pI at pH 7.4, where electrostatic repulsion between molecules is smallest. The last column applies the rules in our dissolving guide to the pH 7.4 charge and the hydrophobic share; it is a starting point for a small-portion test, not a measured solubility.
Why distance from the pI matters
Tedeschi et al. (2017) built variants of a disordered protein that shared hydrophobicity but differed in net charge per residue and pI. They report a solubility minimum close to each variant's pI, with a pH-dependent drop that was not uniform and was driven by the net charge per residue. Furukawa et al. (2020) describe pI precipitation: proteins in either native or denatured conformations often aggregate at the pI, and α-synuclein formed amyloid fibrils at its pI of 4.7 under low-phosphate conditions. Both are studies of proteins rather than short peptides, but the underlying electrostatics is the reason charge is the first thing to check. In practice, a peptide whose pI is near the pH of your buffer is the one to dissolve in water or dilute acid or base first and adjust afterwards, rather than directly in the final buffer.
Limits of a charge table
- Hydrophobic content. A peptide with half or more hydrophobic residues and little charge is the case where charge does not help; see the DMSO and DMF advice, including the cysteine and methionine caveat, in the dissolving guide.
- Counter-ions and modifications. The salt form changes the weighed mass, not the charge arithmetic (TFA and other counter-ions). Terminal caps change the charge count; the table lists them (peptide modifications).
- Stability at the chosen pH. Deamidation and disulfide chemistry depend on pH as well; see peptide stability and shelf life and degradation pathways.
- Metal complexes. GHK-Cu is a copper complex whose speciation depends on pH; it is not in this table (GHK-Cu in mass spectrometry).
Worked example
MOTS-c (MRWQEMGYIFYPRKLR) has three basic residues (two Arg and one Lys) plus a free N-terminus against one Glu and a free C-terminus. The table puts its pI at 10.3 and its charge at pH 7.4 at +2.8, so it is a candidate for sterile water first, with its two methionines and one tryptophan arguing for degassed solvent and short storage in solution. LL-37, with a pI of 11.0, is strongly positive across the whole range from pH 2 to pH 9, whereas Thymosin alpha-1, with a pI of 3.8, is strongly negative at pH 7.4.
Related
- N- and C-terminal modifications and mass spectrometry
- Peptide reconstitution: concentration and volume math
- Bacteriostatic water vs sterile water
- Peptide reconstitution calculator
References
- Thurlkill RL, Grimsley GR, Scholtz JM, et al. (2006). pK values of the ionizable groups of proteins. Protein Sci 15:1214-8. PubMed 16597822 · DOI
- Grimsley GR, Scholtz JM, Pace CN (2009). A summary of the measured pK values of the ionizable groups in folded proteins. Protein Sci 18:247-51. PubMed 19177368 · DOI
- Tedeschi G, Mangiagalli M, Chmielewska S, et al. (2017). Aggregation properties of a disordered protein are tunable by pH and depend on its net charge per residue. Biochim Biophys Acta Gen Subj 1861:2543-2550. PubMed 28890401 · DOI
- Furukawa K, Aguirre C, So M, et al. (2020). Isoelectric point-amyloid formation of α-synuclein extends the generality of the solubility and supersaturation-limited mechanism. Curr Res Struct Biol 2:35-44. PubMed 34235468 · DOI
Frequently asked questions
How do I calculate a peptide's net charge at pH 7?
Add the charges of the ionisable groups: about +1 for each Lys, Arg and free N-terminus and −1 for each Asp, Glu and free C-terminus, with His mostly neutral. This page computes the fractional charge at four pH values from the pK values Thurlkill et al. (2006) measured in alanine pentapeptides.
What is the isoelectric point of a peptide?
The pH at which its net charge is zero. The table on this page gives it for 18 peptides; on the pK set used it ranges from 3.5 (DSIP and Epithalon) to 11.5 (Selank).
Why is a peptide least soluble near its isoelectric point?
With no net charge there is less electrostatic repulsion between molecules. Tedeschi et al. (2017) report a solubility minimum close to the pI for engineered disordered proteins, and Furukawa et al. (2020) describe aggregation of α-synuclein at its pI; both are protein studies, so treat the principle as a starting point for peptides.
Does net charge alone predict solubility?
No. Hydrophobic content, length and aggregation tendency also matter. The table shows the hydrophobic share beside the charge, and a mostly hydrophobic peptide with near-zero charge is the case where an organic co-solvent is usually needed (see our dissolving guide).
Do the pK values change for a peptide with modified ends?
Yes. An acetylated N-terminus or an amidated C-terminus removes that group's charge, and the table treats each peptide's ends as listed on its compound page.